• No results found

University of Groningen Precipitate evolution in grain oriented electrical steel and high strength low alloy steel Zhang, Xukai

N/A
N/A
Protected

Academic year: 2021

Share "University of Groningen Precipitate evolution in grain oriented electrical steel and high strength low alloy steel Zhang, Xukai"

Copied!
3
0
0

Bezig met laden.... (Bekijk nu de volledige tekst)

Hele tekst

(1)

University of Groningen

Precipitate evolution in grain oriented electrical steel and high strength low alloy steel

Zhang, Xukai

DOI:

10.33612/diss.133163231

IMPORTANT NOTE: You are advised to consult the publisher's version (publisher's PDF) if you wish to cite from it. Please check the document version below.

Document Version

Publisher's PDF, also known as Version of record

Publication date: 2020

Link to publication in University of Groningen/UMCG research database

Citation for published version (APA):

Zhang, X. (2020). Precipitate evolution in grain oriented electrical steel and high strength low alloy steel. University of Groningen. https://doi.org/10.33612/diss.133163231

Copyright

Other than for strictly personal use, it is not permitted to download or to forward/distribute the text or part of it without the consent of the author(s) and/or copyright holder(s), unless the work is under an open content license (like Creative Commons).

Take-down policy

If you believe that this document breaches copyright please contact us providing details, and we will remove access to the work immediately and investigate your claim.

Downloaded from the University of Groningen/UMCG research database (Pure): http://www.rug.nl/research/portal. For technical reasons the number of authors shown on this cover page is limited to 10 maximum.

(2)

8.2 HSLA staal

141

List of Publications

(1) X. Zhang, C. loannidou, G. H. ten Brink, A. Navarro-López, J. Wormann, J. Campaniello, R. M. Dalgliesh, A. A. van Well, S. E. Offerman, W. Kranendonk, B. J. Kooi, Microstructure, precipitate and property evolution in cold rolled Ti-V high strength low alloy steel, Materials and Design, 192 (2020) 108720.

(2) X. Zhang, J. Momand, G. H. ten Brink, S. Melzer, S. de Graaf, J. Wormann, H. Pattabhiraman, W. Kranendonk, B. J. Kooi, Precipitation evolution in grain oriented electrical steel during simulated high temperature coil annealing, to be submitted. (3) X. Zhang, J. I. Tjepkema, W. Kranendonk, B. J. Kooi, Recrystallization kinetics and

texture evolution of cold-rolled Ti-V high strength low alloy steel, to be submitted. (4) X. Zhang, G. H. ten Brink, V. Ocelík, J. Campaniello, R. Li, W. Kranendonk, B. J.

Kooi, Continuous annealing of cold-rolled Ti-V high strength low alloy steel: Early stage precipitation and recrystallization behavior, ready to be submitted.

(5)

M. X. Guo, X. K. Zhang, J. S. Zhang, L. Z. Zhuang, Effect of Zn addition on the precipitation behaviors of Al–Mg–Si–Cu alloys for automotive applications, Journal of Materials Science, 52 (2017) 1390-1404.

(3)

List of Publications

Referenties

GERELATEERDE DOCUMENTEN

CSI staat voor Caregiver Strain Index, een vragenlijst waarmee overbelasting door mantelzorg gemeten kan worden.. Het instrument is ontwikkeld in de Verenigde Staten in 1983

Chapter 4 Microstructure, precipitate and property evolution in cold- rolled Ti-V high strength low alloy steel

The strength and hardness of a large number of metal alloys, for example, aluminum-based alloys, nickel-based super-alloys, titanium alloys and certain types of

The following sections focus on the various characterization techniques, including visible light microscopy (VLM), scanning electron microscopy (SEM), electron

(5) The matrix dissolution method allowed the separate volume fraction determination of the three types of precipitates present in the CR and annealed samples,

In Chapter 6, the effects of different soaking temperatures and times on the microstructure and mechanical properties were revealed after precipitation and recrystallization

Afgezien van type I en II precipitaten, werden type III sferische (Ti,V)C-precipitaten waargenomen in de isotherme gegloeide monsters (zie hoofdstuk 4), terwijl type III

I would like to express my thanks to other collaborators in Tata Steel, Stefan Melzer for the discussion on GO electrical steel, Jean Campaniello for the discussion on HSLA