UOW THESIS CLASS FOR L
ATEX 2ε
A Thesis Submitted in Partial Fulfilment of the Requirements for the Award of the Degree of
Master of L
ATEX Art
fromUNIVERSITY OF WOLLONGONG
by
Lei Ye
BEng, PhD
School of Computer Science and Software Engineering Faculty of Informatics
c
Copyright 2007 by
Lei Ye
CERTIFICATION
I, Lei Ye, declare that this thesis, submitted in partial fulfilment of the requirements for the award of Master of LATEX Art, in the School of Computer Science and Software
Engineering, Faculty of Informatics, University of Wollongong, is wholly my own work unless otherwise referenced or acknowledged. The document has not been submitted for qualifications at any other academic institution.
(Signature Required) Lei Ye
Dedicated to
Table of Contents
ABSTRACT . . . ii Acknowledgements . . . iii 1 Introduction 1 1.1 Overview . . . 1 1.2 Another Section . . . 2 2 Literature Review 3 3 Conclusion and Future Work 4 A LATEX Resources 5References 6
UoW Thesis Class For L
ATEX 2ε
Lei Ye
A Thesis for Master of LATEX Art
School of Computer Science and Software Engineering University of Wollongong
ABSTRACT
My abstract goes here.
Acknowledgements
I would like to thank ...
Chapter 1
Introduction
This is my chapter 1 Intorduction.
1.1
Overview
This is my Overview section
1.2. Another Section 2
1.2
Another Section
Chapter 2
Literature Review
This is my Literature Review chapter.
Chapter 3
Conclusion and Future Work
This is my Conclusion and Future Work chapter.
Appendix A
L
A
TEX Resources
This is my appendix A on LATEX [1]. More info can be found at
http://www.uow.edu.au/~lei/resources/latex/.
References
[1] Frank Mittelbach and Michel Goossens. The LATEX Companion. Addison-Wesley,
Reading, MA, USA, 2nd edition, 2004.